Trouble Shooting / General Engine

2119 topics in this forum

1. 77 280z won't stay running, no idle, out of ideas

   By akanning, February 24, 2017
   • 11 replies
   • 2k views
   • 
   • Zeebra
   • Wednesday at 02:52 PM

3. Heat soaked 1 2

   By Dom 280z, September 6, 2017   

   • overheating
   • 1977z
   • (and 3 more)

     Tagged with:

     • overheating
     • 1977z
     • 280z
     • help
     • please
   • 20 replies
   • 1.8k views
   • 
   • Smokescree
   • May 29

4. My 78 280Z Starts and Runs Great But... Ignition Switch Issue Switch?

   By FlyingL, May 11
   • 3 replies
   • 309 views
   • 
   • jhm
   • May 26

5. My 78 280Z Starts and Runs Great But... Ignition Switch Issue Switch?

   By FlyingL, May 10
   • 0 replies
   • 116 views
   • 
   • FlyingL
   • May 10

6. Not getting fuel to the carbs!

   By bravemushi260z, April 30
   • 1 reply
   • 196 views
   • 
   • bravemushi260z
   • April 30

7. SBC 350 Surging at Low Speed Cruise - Vacuum Gauge Reading Interpretation?

   By Miles, February 5
   • 2 replies
   • 835 views
   • 
   • Miles
   • February 6

8. grounding locations for ecu.

   By wickiewicked240z, May 21, 2014
   • 12 replies
   • 2k views
   • 
   • Casanova702
   • January 17

9. L28et powerband issue

   By Nicksturboz2, June 3, 2018   

   • turbo
   • wont rev
   • (and 1 more)

     Tagged with:

     • turbo
     • wont rev
     • engine rotated backwards
   • 11 replies
   • 1.7k views
   • 
   • NewZed
   • November 24, 2020

10. mystery rear main seals included with new round seal

    By Mayolives, September 22, 2020
    • 3 replies
    • 705 views
    • 
    • NewZed
    • September 23, 2020

11. Mysterious Coolant leak

    By Oblithian, June 17, 2020
    • 4 replies
    • 1.1k views
    • 
    • Oblithian
    • September 14, 2020

12. #6 fouling 1 2

    By madkaw, November 7, 2019
    • 33 replies
    • 2k views
    • 
    • madkaw
    • April 30, 2020

13. Sudden engine stops (280z)

    By Villeman, April 2, 2020
    • 5 replies
    • 587 views
    • 
    • Villeman
    • April 4, 2020

14. 260Z dies under accleration

    By gb20, March 26, 2020
    • 3 replies
    • 473 views
    • 
    • gb20
    • March 27, 2020

15. 280z runs well but when I stop at a light it can’t hold an idle for too long

    By Jacobieee, March 23, 2020   

    • 280z
    • bad idle
    • 0 replies
    • 0 views
    • 
    • Jacobieee
    • March 23, 2020

16. 280z runs well but when I stop at a light it can’t hold an idle for too long

    By Jacobieee, March 23, 2020   

    • 280z
    • bad idle
    • 0 replies
    • 0 views
    • 
    • Jacobieee
    • March 23, 2020

17. 280z runs well but when I stop at a light it can’t hold an idle for too long

    By Jacobieee, March 23, 2020
    • 0 replies
    • 0 views
    • 
    • Jacobieee
    • March 23, 2020

18. 280z runs well but when I stop at a light it can’t hold an idle for too long

    By Jacobieee, March 23, 2020
    • 0 replies
    • 0 views
    • 
    • Jacobieee
    • March 23, 2020

19. Just need some opinions

    By Texas7131, January 19, 2020
    • 2 replies
    • 837 views
    • 
    • jhm
    • January 28, 2020

20. wont shift into gear

    By nzarano, December 24, 2019   

    • trans
    • clutch
    • (and 2 more)

      Tagged with:

      • trans
      • clutch
      • slave cylinder
      • wont shift
    • 1 reply
    • 575 views
    • 
    • bunkhouse
    • December 24, 2019

21. Another No start/Hard start

    By BoostLee, November 17, 2019
    • 2 replies
    • 509 views
    • 
    • BoostLee
    • November 20, 2019

22. Aftermarket Fuel Sending Unit?? (280z)

    By Zeestroyah, November 2, 2019
    • 5 replies
    • 609 views
    • 
    • Zeestroyah
    • November 2, 2019

23. Transmission whine or diff whine?

    By pochie45566, September 13, 2019
    • 4 replies
    • 801 views
    • 
    • silverado22c
    • September 13, 2019

24. My car dies apparently loosing all power after a 10 minute drive, the car will restart as if normal and I can drive away afterr 5-10 minutes of waiting as if something electrical needed to cool down.

    By Frank J, August 25, 2019
    • 6 replies
    • 827 views
    • 
    • bfg
    • September 10, 2019

25. Throw out bearing clip

    By pochie45566, September 9, 2019
    • 1 reply
    • 514 views
    • 
    • silverado22c
    • September 10, 2019

26. broken stud, then extractor...can't remove reminisce

    By scartail, July 22, 2019
    • 5 replies
    • 770 views
    • 
    • twofouroh
    • September 3, 2019