94' LT-1 oil press sensor wires location

[hanomon]

Can someone with an LT-1 tell me where on the female end of the factory clip do the Red-Tan-Yellow wires go off the engine oil sense?

 

I know the center bottom is blank but, I'm clueless as to the locations of the three leads.

 

Me being the retard that I am, neglected to notice exactly where in the clip they were before removing all three of them duh!

 

I've fed the entire modified factory harness through a 3/4" gromet hole for the firewall (took approx 5hrs) as almost every wire had to be seperated from it's clip and then reattached.

 

All the others went well after that oops, however, my service manual dosen't specify where on the clip they are and I don't want to pay the enterance fee$ for the jy just to go look at one.

[wheelman]

Do you mean the connector that plugs into the PCM?

If so my wires from the oil pressure switch didn't connect to the PCM, 2 went to the under hood fuse box to run the fuel pump relay and the third (tan) went to the oil pressure gauge. I didn't use the tan one because I have a pressure switch rather than a pressure sender and I'm using the Datsun oil pressure sender.

 

The connector for the oil pressure switch is basically round and the wires connect to it as follows:

Tan - Middle

Grey - opposite side of notch that ensures correct plug orientation

Orange - same side as orientation notch.

 

I hope this helps.

Wheelman

[hanomon]

Yes! that's it.

Thanks wheelman,

U-da-man!