Briguy280Z Posted September 3, 2005 Share Posted September 3, 2005 This will be updated as things roll-on Installation of the Q45 R-200 vlsd into a 280Z R200 housing. So far I have gathered the nessessary parts for the drive axles (or so it seemed) I picked up a Q45 lsd with drive axles at a local yard. I also got some 5 bolt flanges off of a 90 300zx. Important things that i could not find on the forum. 1- 5 bolt flanges are not the same spline count as the 6 bolt flanges 5 bolt flange is 27 count 6 bolt flange is 30 count I confermed this fact today. Not sure if its easyer to get a nother set of compaintion flanges that are 6 bolt or just have the shafts to fit? next task find a machine shop that will cut the axles and respline(if there is such a thing.) to a 27 count spline so that i will have one side 27 and other 30. Some things i need to know from the experienced members. How would i measure the shaft length from center to center of the flange adapters? Any help on this would be great! I will be pulling the differential down to remove the core soon. I remember reading the it takes some force to pry out the differential flanges. Cupple of prybars and a hammer should do it. Anyone please drum in any help would be appreaciated. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.