roller Posted September 19, 2006 Share Posted September 19, 2006 should i bottom it out in the mc and then back out how much? Quote Link to comment Share on other sites More sharing options...
johnc Posted September 19, 2006 Share Posted September 19, 2006 The FSM specifies a pushrod height of 3.5 to 4mm (.1377 to .1575") measured from the flange surface (the aluminum plate bolted to the master vac hosing) to the tip of the pushrod. I would adjust the pushrod so there is about ..010" clearance between the tip of the pushrod and the cup at the back of the MC. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.