Guest zerzat Posted May 2, 2007 Share Posted May 2, 2007 i am wanting to put a sbc in my 280zx but since it is an old unibody i was wondering if there were any places in particular i should brace up to minimize chassis torquing Quote Link to comment Share on other sites More sharing options...
80LS1T Posted May 3, 2007 Share Posted May 3, 2007 Well, front strut bracing helps and a 4 point rollbar will help(unless you want a full cage?). You can buy a 4 point roll bar from www.zcarparts.com . But you will have to make your own front strut bracing. I have a 3 bar set up in my car up front that I made and the 4 point rollbar from the above website. Guy Quote Link to comment Share on other sites More sharing options...
dustin280zx Posted May 3, 2007 Share Posted May 3, 2007 I'd check your floor pans for rust first. Both my passanger and drivers side are rusted out. Cant weld in my roll cage if i dont have nothing to weld too. Haha. Quote Link to comment Share on other sites More sharing options...
Guest zerzat Posted May 4, 2007 Share Posted May 4, 2007 actually i have already replaced my passanger floor pan Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.