jeffer949 Posted December 30, 2007 Share Posted December 30, 2007 ok im getting an error message when i start megatune after i select which code to use which at the moment is just ms1 no msns yet(just assembled it) and then this error message comes up before it opens. any body have any ideas??? also it comes up regardless to weather or not i have my ms connected through the serial cable with the stim on or not Quote Link to comment Share on other sites More sharing options...
mario_82_ZXT Posted December 30, 2007 Share Posted December 30, 2007 The active code in Megatune doesn't match that of your MS box. Quote Link to comment Share on other sites More sharing options...
jeffer949 Posted December 30, 2007 Author Share Posted December 30, 2007 but i have it set for the MS1 original BG code and isnt that what the 68HC908 processor comes flashed with??? and it also does it even if i dont have the board connected to the serial cable... make sense?? Quote Link to comment Share on other sites More sharing options...
niner11 Posted December 30, 2007 Share Posted December 30, 2007 Your ini file has to match what the controller (MS) is using. I have never messed with MSI but it should be the same principle as MSII. You configure megatune to match the code (firmware) that your processor is using. Quote Link to comment Share on other sites More sharing options...
jeffer949 Posted December 30, 2007 Author Share Posted December 30, 2007 ok how do i change that? or find out what is on my ecu?? Quote Link to comment Share on other sites More sharing options...
mario_82_ZXT Posted December 30, 2007 Share Posted December 30, 2007 It's easiest to reflash your ECU with the code you want, and it comes with the INI file to boot. That way you KNOW what's actually in the processor. Mario Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.