giorgio61 Posted October 7, 2009 Share Posted October 7, 2009 I am planning on going with flat top pistons in my rebuild (N42 block), nothing fancy just ZX stock, however when I requested these from my ITM supplier he asked me to make sure my wrist pin size was 22mm. I have three sets of L28 rods and all are 21mm, L24 are 21mm as well. I have searched this forum and every webplace I can think of, and could not find mention of wrist pin diameter. Is he correct? What am I missing? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.