Jump to content
HybridZ

'77 harness.. remove all of it for v8


snork

Recommended Posts

I have removed the engine/tranny from my 77 z for a ford 302. After removing the computer I was going to remove the harness that snapped into the computer. But I noticed that the harness went up into the dash. So what all is controlled by the computer in the dash? Plus, do I need any of that wiring harness to run the carbed 302? In the JTR book, there were only 7 or 8 wires needed to run the motor and gauges. I'm getting very discouraged right now, need help!

Link to comment
Share on other sites

I have removed the engine/tranny from my 77 z for a ford 302. After removing the computer I was going to remove the harness that snapped into the computer. But I noticed that the harness went up into the dash. So what all is controlled by the computer in the dash? Plus, do I need any of that wiring harness to run the carbed 302? In the JTR book, there were only 7 or 8 wires needed to run the motor and gauges. I'm getting very discouraged right now, need help!

 

The EFI harness is on the drivers side of the engine and is only connected to the ECU and some relays under the drivers side of the dash. If your trying to remove the harness on the Passenger side of the engine bay your removing the wrong harness.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...