snork Posted September 2, 2010 Share Posted September 2, 2010 I have removed the engine/tranny from my 77 z for a ford 302. After removing the computer I was going to remove the harness that snapped into the computer. But I noticed that the harness went up into the dash. So what all is controlled by the computer in the dash? Plus, do I need any of that wiring harness to run the carbed 302? In the JTR book, there were only 7 or 8 wires needed to run the motor and gauges. I'm getting very discouraged right now, need help! Quote Link to comment Share on other sites More sharing options...
19762802+2 Posted September 2, 2010 Share Posted September 2, 2010 I have removed the engine/tranny from my 77 z for a ford 302. After removing the computer I was going to remove the harness that snapped into the computer. But I noticed that the harness went up into the dash. So what all is controlled by the computer in the dash? Plus, do I need any of that wiring harness to run the carbed 302? In the JTR book, there were only 7 or 8 wires needed to run the motor and gauges. I'm getting very discouraged right now, need help! The EFI harness is on the drivers side of the engine and is only connected to the ECU and some relays under the drivers side of the dash. If your trying to remove the harness on the Passenger side of the engine bay your removing the wrong harness. Quote Link to comment Share on other sites More sharing options...
snork Posted September 3, 2010 Author Share Posted September 3, 2010 This harness is on the driver's side. It is the harness coming off the computer. I take it, it is safe to sh#t can the harness then? Part of that harness does snake onto the passenger side. Thanks for answering! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.