Z-carforlife Posted October 15, 2010 Share Posted October 15, 2010 Hey guys, Ok here goes! I have a set of RB25det top feed O-ring injectors that OHM at 12.5-.7 I am currently running Stock setup on my L28et 83 harness/ecu and injectors. I would like to use the RB25et injectors but they are high impedance and the stock setup is low impedance, What would i need to do to run these injectors With the Stock ECU and harness? Any help on this would be great! Quote Link to comment Share on other sites More sharing options...
z-ya Posted October 15, 2010 Share Posted October 15, 2010 Hey guys, Ok here goes! I have a set of RB25det top feed O-ring injectors that OHM at 12.5-.7 I am currently running Stock setup on my L28et 83 harness/ecu and injectors. I would like to use the RB25et injectors but they are high impedance and the stock setup is low impedance, What would i need to do to run these injectors With the Stock ECU and harness? Any help on this would be great! Probably just remove the resistor pack, but I've never done it, and don't know for sure. The only way to be sure is to understand the stock ECU injector drive circuit, and then scope the outputs when driving the high Z injectors to make sure that they are opening all the way. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.