So I did every test under the No start category of the FSM, including the voltage checks and what i've found is this.
1(6) water temperature sensor (13-ground) has no continuity
1(8) Air regulator and fuel pump (34-ground) has no continuity
2(2) Power line circuit is (10-ground) is only reading .04 volts
2(3) injector and dropping resistor terminal steps
A(cylinder 4, 14-ground),
B(cylinder 1, 15-ground),
C(cylinder 5, 30-ground),
D(cylinder 6, 31-ground),
E(cylinder 3, 32-ground),
F(cylinder 2, 33-ground) all are reading .04 volts
3(2) Air regulator - It didn't say to do this one, but it was only reading .05 volts at "start"
The line before the relay, after air regulator is the one that is the problem from what i can tell from the checks for the fuel pump not working, what should I do now, follow that wire and change it out? Lost please give tips.