Clifton

Didn't see this until today. I was running a 17x8 in the front with a 25mm offset. I pushed them out 10mm so I think a 9" with a 35mm offset would work. It would only be 5mm out more than mine. On the rear I ran a different hat than his standard that was thinner with a 35mm wheel and it was perfect. Dave and I went over all the measurements on the rear with both hats and a 43mm 17x9 was within 1mm of how my set up is. If you aren't running adj arms in the rear I would run a 43mm 17x9. You can always space it out a mill or two but if you are our 5mm too much it will rub. If you are only going to run a 255 you will have a little more tire room. I ran a 245 on an 8 and 275 on the 9. I rolled the front when I painted but not before and it didn't rub. Watch the front lower fender when turned though. I trimmed the inner rear with a grinder after I painted when I went to a MT drag radial. They are pretty wide for a 275.

Clifton