tunerpike

Thanks Matt! I believe I can figure it out between the drawings. If I have any more questions I will be sure to post. I appreciate everyone's help.

Just incase you guys can't make it out, it says Megasquirt V3.8 and PCB 1.1 Notice the built in 4 bar MAP sensor...

Thank you both for the help... Here is a pick of the board. I am sure that I will have more questions as I get more into it.

Thank you both for your time. Randy, so your saying the diagram I posted is correct, other then I need to take the fidle wire to the small gauge yellow wire on the igniter? Also, where is best place to run all the grounds. 10mm on the intake? NewZed are you saying this is an MS1 with MSnS?

Hey Guys, I am needing a little help... My uncle has a 83' 280zxt, he knows absolutly nothing about wiring etc.. So, he sprung for the EMS Pro that has been sitting in the box for over 2 years. I am an electrical engineer and have wired up a few cars, so I told him the other day that I would do it for him. I already have the stock wiring harness out of the car, as well as other things that I don't plan to use. I believe this EMS Pro is based on MS1, I am not really sure though. I really just want to do a basic install, using the 83' dizzy and possibly stock injectors. I have a GM map, IAT, Coolent temp and tps. I have read that the tps out of a automatic car is a potentiometer type. Is that true? IF so, it would be easier to install. I have found this diagram to wire by, I just wanted to make sure that it pertains to the EMS Pro. Also, do I have to use an MSD in order to make this work? http://imageshack.us/f/379/megasquirtmsdkcjversioncopy7fe.jpg/ I really appreciate any help that you guys can offer. Normally I would have done months and months of research before tackling a project like this and to be honest I really don't know what to search for. This is just a black box with fancy blue leds sitting in front of me.