tylerd280zx
-
Posts
16 -
Joined
-
Last visited
Content Type
Profiles
Forums
Blogs
Events
Gallery
Downloads
Store
Everything posted by tylerd280zx
-
So I cleaned the IAC and still nothing....car has a hesitation when giving it the throttle. Only at idle once its up in the rpms a little its fine .also when its at idle and you give it the throttle it sounds like the intake makes a odd sucking noise. the hesitation is just for a second or two the will rev like normal thru the higher rpms
-
From the album: 280ZX
just got it running after picking it up in a garage. sat for 15 years i drained the fuel system put new injectors,filter,plugs ,wires,cap and button. put alittle bit of out down the cylinders and fired right up. -
-
-
From the album: 280ZX
new plugs, injectors, wires, cap, button, still had cold a/c ran good no grinds. -
From the album: 280ZX
-
From the album: 280ZX
made mount to clear the pan and cross member -
From the album: 280ZX
had to have had the motor in and out 25 times fitting it. oil pan didnt like to clear. the turbo drain didnt want to clear the rack. screamer pipe had to be trimmed. the driveshaft had to be cut down. tranny mount had to be slotted. oil pan had to be cut flipped and metal added due to not matching up after flipping. the oil pick up tube was cut and turned.......well worth spending $600 for a pan what a pain... probably forgetting a few stumbles but shes in now. -
From the album: 280ZX
put her up in the rear to get the tranny in -
From the album: 280ZX
little dirty -
From the album: 280ZX
-
From the album: 280ZX
-
From the album: 280ZX
-
From the album: 280ZX
dont mind the bag over the tach it was about to rain. dont really trust the water resistant tach. -
I did away with a few things and added a few hope the pic is clear enough to see mostly what I've done.. . Since the pic I added a fpr....due to my plugs showing really lean. I took it down the road feels sluggish and like I hit a wall at 4k plus I have the idle problem....checked for codes and shows 55 all is OK. I'll check the IAC motor pintle.
-
-
I swapped a rb20det in my 1982 Datsun 280zx. Starts drives just has an idle issue. It will idle at a thousand rpms for 20 sec or so then it will drop down and wanna die sometimes it does. If it doesn't it will after 10 to 15 seconds it will kick back up and just start all over again any help would be awsome
