Bangkok Z

Rayaap2 i just was going to get started with ur recommendation and before i could even get the wires ready,I noticed the wiring in the engine compartment looked to be very dirty and crispy to the touch. I also took sho-z's recommendation and it look so far that i will start with both of ur advise and clean all of the connections. Thanks again and will ya posted. Sho-Z i was curious but did ur lights all of a sudden stop working when u had a similar problem? Oh and by the way I notice on the link for this wiring diagram i noticed there is a accessory relay. since i will be under the dash and engine compartment would anyone happen to know whereabout is this located.Thanks http://www.atlanticz.ca/zclub/techtips/electrical.htm

Had a bad Tach and fixed that with a replacement. But now all of a sudden my combo light switch won't turn on the headlights nor the driving lights and the turn signals don't work.When i step on brake pedal the brake lights work and when i turn on the emergency flasher that also works. I have no idea about electrical wiring and dont know where to start. I did however replaced the combo and the turn signal switches because the combo switch was bad and the turn signal switch i just had lying around. Before i get into tracing wires and learning as i go is there any relays or something that might have just burnt out or wires that might been missed plugged ? so far all fuses are good. And it was working before the replacement of tach.Thanks in advance.

Thanks you bjhines i have a better understanding with pic. Found out that it was a bad Tach! Special thanks to Rayaapp;)

K will try that and see if it works. But for some reason I think I have the wiring hooked up wrong at the coil and resistor but again it starts and runs fine until I hook up the tach.Really confused. Thanks will let you know.

O.k so I had a Pertronics igniter put on my 240z without the dash or gauges in the car and it fired up fine a few months back but when i reinstalled the dash back in with the stock gauges hooked up i notice it wont start (no spark)but cranks. But when i unplugged the speedo wiring connectors behind the dash(where harness connects to speedo) it fires right up.Anyone running a pertronics igniter can help with wiring or problem? Its a 70 240Z and i am running a ballast resister with the pertronic with a after market coil. Thanks in advance

I really only need a driver side lock cylinder and a key for it.But if you have a set let me know and a price.Thanks

Not sure if you might have missed my post http://forums.hybridz.org/showthread.php?t=158719 If you like it PM me a reasonable offer. It's a 15x7 with 0 offset and comes with tires.

I also have one for 350$firm and i'm in Sacramento,Ca

Sill looking.Thankz

Thanks Inferno 08.Got it.

Got good pic of it?And how much?Please PM.Thankz

I not sure If all 240Z front bumpers are the same,anyways I'm looking for one.I have a early production 10-1969 Z and need all brackets also.I'm located in Sacramento,Ca.Thankz

Madkaw,that's exactly what I was thinking about,can't wait for you to be done with it and hear it.What size piping did you go with and how does it tuck underneath it all?Don't mind me ask what engine are you running and what mods?