Search the Community
Showing results for tags 'foam'.
-
I am in the middle of some bodywork, but before I can re-assemble my '75 280z I need to replace the foam pieces that brace the front fenders and outer door panels. Mine had all either dissolved or were torn when the panels were removed. Does anyone know the factory thickness of the foam so I can find a suitable replacement?
-
Here is how I refinished my seats: I stripped the paint off the frames, used the POR marine cleaner, then used the POR metal etcher, then painted with POR-15 I used metal wire to tie the seat springs back together I used thin carpet squares on top of the seat springs to protect the foam I recovered the lower parts, clamping the inner wire with hog rings to the frame underneath. Tip: heat up the covers in the sun first I made new wires to hold the upper portion to the seat back, and fastened with hog rings. I placed a plastic bag on top to make fitting the cover easier. I pulled the vinyl covers onto the top. I got these covers from Ebay for $200 and was very happy with the quality. I requested this design, with the vent grommets eliminated and orange stitching. I cut out new rubber guards. I repainted and greased the mechanisms, then reattached them to the seats. Tip: use an impact driver, not a regular screw gun, or drill. Elapsed time: 1 weekend. So after all that, I installed them to discover that with the new seat foam, the seats are too high, and I preferred my old seats. haha. At least they look good.
- 9 replies
-
- seats
- upholstery
-
(and 3 more)
Tagged with: