Search the Community
Showing results for tags 'fork'.
-
I have a 1972 240z with an L28 and 5 speed transmission, all swapped before I got the car. I just finished a clutch replacement where I; replaced the rear main seal, pilot bushing, clutch and pressure plate, had the flywheel resurfaced and replaced the the outer seals and gasket on the transmission. Refilled transmission with Redline MT-90 and bled the slave cylinder with Valvoline DOT 3&4 synthetic brake fluid. I did all this just to find out that it was the hydraulic system, the clutch was fine. I believe my problem is that I ordered a 1977 slave cylinder however I for some reason still have the 'old' clutch fork with the hole for the adjustable rod. I thought no problem Ill just Swap the adjustable rod from the one on the car with the new one. I did this and tried to properly adjust the slave cylinder but was a bit confused by the fsm. should I push the slave cylinder rod all the way in and pull the fork to the back of the car then adjust the nut to 1.5 turns out from touching the fork? Will this setup not work and I should order a new '72 slave? The car is current on stands and when I start the car in first with the clutch in the wheel still spin.
- 3 replies
-
- clutch
- transmission
-
(and 2 more)
Tagged with:
-
Hey All, I've searched all over for this topic and can't quite find what I'm looking for. Part of it may be my being green in the drivetrain area. I took a 76 280z (CA) and put the motor and 5spd from a 77 280z (2+2) in. After getting everything in place, the car drives and goes through gears 1-4 okay. It won't go into 5th no matter what and has a little trouble with reverse. From what I've read this sounds like a shift fork replacement is in order. I don't see any interference issues with the shifter and tunnel. 1) Would you put your money on this needing a fork replacement? 2) If so, I assume this requires pulling the trans... I'm a little hesitant with my skill level to make any assumptions at this point and start dissecting 3) Any guides or advice on approaching this? Note: I do have the 4 speed I pulled out of the car if there is anything I can use from it. Sorry for the naivety... I'm dying to finally get some summer fun out of this thing. Thanks!