Search the Community
Showing results for tags 'glazed'.
Found 1 result
-
I've probably pulled my front wheels off 5 times messing with these brakes and now I need to ask for advice. The car is a '75 280z, all stock brake components except for maybe the pads. They're the same ones I bought with the car 1 and a half years ago. Every time I brake I get this HORRIBLY loud squeak/squeal/grind noise coming from both the front wheels. The noise changes depending on how hard I brake, sometimes if I brake really hard it doesn't squeal at all except maybe a little noise. The loudest noises come from light braking. All of my front brake pads have plenty of meat left on them. They honestly look new there's so much. Every time I've checked the pads and rotors they've been glazed. So I pull off the pads and sand them pretty good with rough sandpaper and do the same with the rotors. After I sanded the pads and rotors on both sides and start driving, it's great. Barely a peep out of them for the first drive. But the next day/couple days later they start progressively making the horrible noise again, and they glaze again. Also I found that if I spin my rotor with the pads and caliper on, I hear kind of a light scraping noise. It only happens on some spots on the rotor, rest is silent. I'm so over dealing with this I think it's time to just buy new rotors and brake pads. Maybe even do the toyota 4x4 caliper swap. But I don't want to spend money on it considering I believe both the rotors and pads have good life on them. I just replaced all studs on my drivers side front wheel and repacked the wheel bearings too, so I don't wanna pull off that rotor again. What do you guys think? Should I just bite the bullet and replace my brakes? Anyone else have similar trouble? My worst nightmare is replacing the rotors and pads to find out it still makes noise. I just want this embarrassing noise gone. Thanks