BenLT Posted September 9, 2011 Share Posted September 9, 2011 (edited) I have a sr20 in my '73 240 using the McKinney mount setup. I'm running in to an issue of the drive shaft rubbing on the e brake support bar that runs from the lever to the other side of the tunnel and connects to the cable. the drive shaft has less than an 1/8" of play between the bar unloaded, when the engine has any load at all (even mild acceleration)it hits and makes an awful noise. Anyone have Any ideas? Edited September 9, 2011 by BenLT Quote Link to comment Share on other sites More sharing options...
palosfv3 Posted September 9, 2011 Share Posted September 9, 2011 Check the little plastic bushing the e/brake cross bar sets into. These have a habit of cracking over time and the e/ brake shaft drops slightly . Quote Link to comment Share on other sites More sharing options...
BenLT Posted September 9, 2011 Author Share Posted September 9, 2011 No dice, that bar is solid. Im thinking about cutting/welding somehting in its place, but I'd rather not. Quote Link to comment Share on other sites More sharing options...
fast-datsun Posted February 10, 2012 Share Posted February 10, 2012 Always call me for problems Mack Quote Link to comment Share on other sites More sharing options...
BenLT Posted March 1, 2012 Author Share Posted March 1, 2012 Always call me for problems Mack I feel like I have been bugging you enough. Anyway i just pulled it out and flattened it now its running fine! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.