Fuzzydicerule Posted June 20, 2012 Share Posted June 20, 2012 Hey all, now that my LS1 swap is running and driving i can finally focus on my exhaust. A few days ago i ordered the lot 2x4' lengths of 3" tubing 1x dual 3" -> Single 3" Magnaflow y pipe 1x Moroso Spiral Flow 1x 3" in, dual 2.5 out Thrush chambered muffler 2x Cherrybomb Dual wall 3" outside, 2.5" inside Polished stainless tips 3x 3" butt joint band clamps Annoyingly, everything but the band clamps showed up yesterday, otherwise the exhaust would be done and on the car right now, but in the down time i decided to do this Since i was going for the 432 style vertical tips, the spacing of the outlets on the muffler just wasnt going to do, it was way too far apart and the mockup looked rediculous I determined that the side of the 2nd (top) pipe should be about even with the base of the cone at the end of the first, So i pulled out my trusty plasma cutter (after my bandsaw did little more than scratch the case) and i ruined my muffler. and a quick mock up of the new spacing and due to being distracted and the wonders of television, here is the finished project. Nothing really to see, just welding it in place and filling the holes. I also had to cut the tips quite a bit, which was a pain, but i cut the entire shank off of the top one, and about an inch past that on the bottom one to get them to stagger a bit. Unfortunately that is it for now, more pics to come on my next day off when i get the exhaust built. Quote Link to comment Share on other sites More sharing options...
v8dats Posted July 23, 2012 Share Posted July 23, 2012 nice. more pics? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.