rayaapp2 Posted November 3, 2013 Share Posted November 3, 2013 Here is an interesting problem. http://performanceworks1.com/ls1_clutch_bleeding.htm There is no bleeder on the slave cylinder for the 96 camaro/firebird. The website above is the only source that gives a solution. I really find it hard to believe that the system is self bleeding. I think I am gonna gravity bleed the line to the cylinder and then attempt to follow these instructions and see how it goes. It seems dumb to not have a bleeder on there for servicing. Quote Link to comment Share on other sites More sharing options...
Domzs Posted November 3, 2013 Share Posted November 3, 2013 Just looked up bleeding procedure ( Mitchell On Demand ) . It's somewhat self bleeding system but requires some strange steps , I have never seen before . Quote Link to comment Share on other sites More sharing options...
jay260z Posted November 3, 2013 Share Posted November 3, 2013 just attach the hose from the master cylinder down to the slave cylinder but dont install the slave cylinder to the transmission yet. Fill the master cylinder with the correct dot fluid then slowly press the rod on the slave cylinder all the way until it bottoms out and slowly let it extend all the way back out, repeat until you have no bubbles. You may let it sit a few to allow any trapped air to rise, once its bled it will self bleed from there Quote Link to comment Share on other sites More sharing options...
rayaapp2 Posted November 6, 2013 Author Share Posted November 6, 2013 That seems to be the way to do it. It sucks but it seems after some fiddling its bled correctly. Ray Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.