tolerate Posted February 1, 2014 Share Posted February 1, 2014 (edited) Hi, I picked up someone else's headache apparantly, Its running the MSnS and I tried connecting to the 9 port with my laptop (car off), I heard a whistling noise, went to check it out and my fuel pressure went to 0. Next I tried to open up tunerstudio to MSnS, no response. Un connected laptop to MSnS Tried to restart the car and the fuel pumps not working.. Did I fry my megasquirt? Edited February 1, 2014 by tolerate Quote Link to comment Share on other sites More sharing options...
skirkland1980 Posted February 1, 2014 Share Posted February 1, 2014 Check power and ground at the 37 pin connector. Which board and cpu are you using? Quote Link to comment Share on other sites More sharing options...
tolerate Posted February 1, 2014 Author Share Posted February 1, 2014 That's a good question how do I check? Quote Link to comment Share on other sites More sharing options...
skirkland1980 Posted February 1, 2014 Share Posted February 1, 2014 Was the car running before? Or are you trying to get it running for the first time? Quote Link to comment Share on other sites More sharing options...
tolerate Posted February 1, 2014 Author Share Posted February 1, 2014 It was running before. Just super rich. The engine kept flooding. I changed the ignition coil because the spark was a yellowish tint at the distributor. And now its a ghost blue. Still flooded so now I'm trying to change the fuel map(?). Quote Link to comment Share on other sites More sharing options...
tolerate Posted February 1, 2014 Author Share Posted February 1, 2014 Of course I cleaned all the grounds, SP, spark wires, and checked all the fuses. And I've also got to change a thermostat somewhere... Quote Link to comment Share on other sites More sharing options...
tolerate Posted February 1, 2014 Author Share Posted February 1, 2014 The cars a 1977 s30 with a 82 zxt engine swap. Quote Link to comment Share on other sites More sharing options...
loy Posted February 1, 2014 Share Posted February 1, 2014 So currently it does not connect to tunerstudio? When you cycle ignition do you see the leds flash? Quote Link to comment Share on other sites More sharing options...
tolerate Posted February 2, 2014 Author Share Posted February 2, 2014 I used to is there a fusenox I can check? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.