FieroLuke Posted February 6, 2018 Share Posted February 6, 2018 Could you send whatever pictures you have on hand to Luke hanus @ yahoo . Com (no spaces). The pics in your blog won't load on the 3 devices I tried. I'm about 4.5 hours away from you, I've gone a lot further than that before for the right car. Quote Link to comment Share on other sites More sharing options...
mditt8671 Posted February 6, 2018 Author Share Posted February 6, 2018 (edited) THIS IS NOT THE CURRENT STATE OF THE CAR. The car has been taken down in preparation to be sandblasted; front fenders, hood, engine grill, etc all removed. R180 rear is gone and have an R200 that goes with it, but it's not installed. Intent was to get it sandblasted and start reassembly. The floor pans are the worst part of it, but the rust doesn't go far and I have the Zedd floor pans to completely replace them (along with frame rails and everything else needed to make this new again). All parts from disassembly have been put in labeled ziploc bags, not just tossed in a coffee can or something. Edited February 6, 2018 by mditt8671 Quote Link to comment Share on other sites More sharing options...
FieroLuke Posted February 6, 2018 Share Posted February 6, 2018 Thank you! Do happen to have any handy of the rockers, wheel well edges and hatch area above the tail lights? What was the original colour of the car? I'm not quite an expert on what is factory vs non factory over spray on a Z Quote Link to comment Share on other sites More sharing options...
mditt8671 Posted February 6, 2018 Author Share Posted February 6, 2018 (edited) I don't have those pics right now but I can get them. The original color was yellow... this has been repainted. They used a reddish primer under the paint. I believe the left rear fender skin was replaced at some point; there is a cut inside the wheel well between the fender/wheel well that really needs to be connected for best structural integrity. I might have a pic of that; I'll try to find it. ETA: found it Edited February 6, 2018 by mditt8671 Quote Link to comment Share on other sites More sharing options...
mditt8671 Posted February 6, 2018 Author Share Posted February 6, 2018 By the way, I don't know if anyone on this site uses it, but I would be willing to take cryptocurrency as well as traditional means of payment. Quote Link to comment Share on other sites More sharing options...
HOLLAATYABOYY1 Posted February 19, 2018 Share Posted February 19, 2018 PM sent Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.