Mikelly Posted April 3, 2003 Share Posted April 3, 2003 Well last night I ran some wire for the pump and filled the pump with Hydraulic fluid and raised my lift for the first time. No big deal. I go to lower it and Fluid SHOOTS out of the fill plug, spraying all over my wall, my pic of the Race 300ZX, and my tool board where all my sockets and ratchets, specialty tools and such are located... It then promtly puked more fluid all voer the floor the more I lowered it... Any tips from those who work with these things??? Did I get an overfill/ air pocket issue??? Mike Quote Link to comment Share on other sites More sharing options...
Mikelly Posted April 4, 2003 Author Share Posted April 4, 2003 ...And to make matters worse, I took yet another bath in fluid TONIGHT and I can' get the lift wiring sorted out... This thing realy was rigged up pretty bad and I'm pretty sure I over filled it by two gallons... Boy what a mess... Think I have it drained back down to the leve it should be at, but I have to get the wiring issues sorted. I have my final inspection tomorrow so I'm just gonna block off the wiring 'till after they leave and then sort it out after wards! Mike Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.