Dan Juday Posted July 3, 2003 Share Posted July 3, 2003 Hey guys, I need a definitive answer on this. Does anyone make angle plug D port blockhuggers that clear the steering shaft on a 280Z in the JTR position? I need to hear from you LT1 guys. Quote Link to comment Share on other sites More sharing options...
Tim240z Posted July 3, 2003 Share Posted July 3, 2003 Dan, (Hate to do this to you), but do a search. This topic came up a little while back and I seem to remember someone providing a source for these headers. Sorry I can't help you specifically as I made my own full length headers (which I am picking up this morning from Rewarder Headers....they high temp coated them!! Tim Quote Link to comment Share on other sites More sharing options...
mas28O Posted July 3, 2003 Share Posted July 3, 2003 Dan I have hooker part# 2100 on my Lt1 without any problems. Mike Quote Link to comment Share on other sites More sharing options...
Dan Juday Posted July 4, 2003 Author Share Posted July 4, 2003 Thanks Mike. I'll check out Hookers web page. No offence taken Tim. I did do a search. There was much talk of LT1's and the 280ZX swap but not a definite answer to the fit in a 1st gen Z, unless I missed something (very posible). I have read that straight plug blockhuggers will work with angle plugs if you change your wires to 90* boots. And they clear the steering shaft just fine as this is what I have on my car. But I would like the better port match and more room for the plugs that the angle plug headers offer. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.