Chaparral2f Posted November 29, 2003 Share Posted November 29, 2003 My block huggers do their job just a little too well. It would be really helpful if they were about a quarter or three eights of an inch further from the side of the engine. Does anyone make a plate that would go between the head and the header? I can make them myself, but it is a major PITA, and if there is someplace to buy them it would be much simpler. Quote Link to comment Share on other sites More sharing options...
denny411 Posted November 29, 2003 Share Posted November 29, 2003 Some companies that sell header kits sell just the flange that bolts to the head. They are almost 1/4" thick and might work well for your purpose. Quote Link to comment Share on other sites More sharing options...
dot Posted November 29, 2003 Share Posted November 29, 2003 I was thinking the same thing ...or you could scrounge up a used flange and clean it up. Quote Link to comment Share on other sites More sharing options...
Trevor Posted December 1, 2003 Share Posted December 1, 2003 "Headers by Ed" http://www.headersbyed.com/chevrole.htm $250 a set if I read it right Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.