GrayZee Posted December 22, 2004 Share Posted December 22, 2004 Yes apologies for hijacking the thread.. Drax, the flange is made of two 1/4" laser cut peices. The reason being we wanted it 1/2" think but the laser cuts are not as good on 1/2 SS (I guess SS is shiny and the laser bounces around alot) We've done water-jet cutting too, but that's alot more expensive. I know you have alot more technical knowlege about the physics of this. All I know is what I "think" would flow better, you may be right about the turbulence at the diffuser but then again I can tell you that I noticed a HUGE difference in the lag. Now it is practially non-existant! On a further note, I'm sure the 2.5" pipe works very well and it is likely not worth swapping to 3" However if you don't have a DP and are building one, my advise would be go to the 3" right off the bat. Quote Link to comment Share on other sites More sharing options...
Thumper Posted December 23, 2004 Author Share Posted December 23, 2004 No problem here I already decided what one I'm using. Plus this is a debate i've had with my friends a couple times. So all this seems familar. Quote Link to comment Share on other sites More sharing options...
fl327 Posted December 23, 2004 Share Posted December 23, 2004 Lets let the dyno prove me RIGHT! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.