Tim240z Posted April 23, 2005 Share Posted April 23, 2005 1 step forward, 2 steps back! I had to remove the in cab tank so that the Leather Suburban seats would fit nicely, so I just decided to use the 2 saddle tanks as primary tanks with a low pressure transfer pump. Well, to do that, I had to remount the high pressure pump to be lower than the side tank, which meant I had to re-route the exhaust (1 inch from pump to exhaust was a little close for comfort), so here is the new exhaust system. Twin 2.5" into single 3", all mandrel bends and lots of welding! Old rusty system that exited in front of the rear wheels: New system that goes over the axle: Quote Link to comment Share on other sites More sharing options...
COZY Z COLE Posted April 23, 2005 Share Posted April 23, 2005 Looking good Tim!!! No " hidden costs " in this project, Right ??? LARRY Quote Link to comment Share on other sites More sharing options...
Tim240z Posted April 23, 2005 Author Share Posted April 23, 2005 Riiiight!!! Actually I did not have to buy any tools bummer! Quote Link to comment Share on other sites More sharing options...
EvilRufusKay Posted April 23, 2005 Share Posted April 23, 2005 That isn't a cat out back is it? Third muffler maybe? EDIT: Make sure your careful when welding galvanised....... Quote Link to comment Share on other sites More sharing options...
Tim240z Posted April 23, 2005 Author Share Posted April 23, 2005 rufus, 3rd muffler. Nothing galvanized there. All aluminized exhaust tubing, which ground off and cleaned at the wels locations....(See Mr. Coffey...I learned something from you) Quote Link to comment Share on other sites More sharing options...
Tim240z Posted May 6, 2005 Author Share Posted May 6, 2005 Just posted the 350 that I took out in the classifieds! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.