rvandivort Posted December 21, 2007 Share Posted December 21, 2007 Hi!, Want to know where the best place to go for this item is..Dodge truck, Holset, or some other aftermarket outlet..online? Thanks a lot. This is the item dumping the oil off the center section to the oil pan via a rubber hose. Quote Link to comment Share on other sites More sharing options...
nish Posted December 21, 2007 Share Posted December 21, 2007 The standard two bolt ones for a T3 and similar fit, so it should be easy to find one. Quote Link to comment Share on other sites More sharing options...
rvandivort Posted December 22, 2007 Author Share Posted December 22, 2007 Thank YOUUU! Quote Link to comment Share on other sites More sharing options...
steveosupremeo Posted December 23, 2007 Share Posted December 23, 2007 someone already answered that for you in your last thread. Quote Link to comment Share on other sites More sharing options...
rvandivort Posted December 26, 2007 Author Share Posted December 26, 2007 Thanks for your response! Maybe I didn`t get it. But, at any rate, it was the wrong thread to be asking the question. So, I decided to go here..and maybe, other folks with the same problem could benefit. You guys down South sure have a lot of Z`s. We have a metro area of about the same size--and I`ve seen one Z with a MSA rear bumper, some stockers. The overwhelming amount are hondas. Thanks again, Roger Quote Link to comment Share on other sites More sharing options...
rvandivort Posted December 26, 2007 Author Share Posted December 26, 2007 I went back and checked to the the previous post.......nothing about a t3 being equivalent. Otherwise, I wouldn`t have started this post! Quote Link to comment Share on other sites More sharing options...
rvandivort Posted December 26, 2007 Author Share Posted December 26, 2007 Thread! Sorry! , But, You get the meaning. You are apparently tight with gearheadstick. That is OK. Loyalty is a good thing--to a point. Anyway, Have Fun with whatever You do! Quote Link to comment Share on other sites More sharing options...
steveosupremeo Posted December 26, 2007 Share Posted December 26, 2007 the stock ZX that gearhead refered to is a T3. i thought everyone knew that. Quote Link to comment Share on other sites More sharing options...
gearheadstik Posted December 27, 2007 Share Posted December 27, 2007 DUUUUUURRRRRR....I Don't understand...DURRRR Quote Link to comment Share on other sites More sharing options...
rvandivort Posted December 31, 2007 Author Share Posted December 31, 2007 I don`t either! But at any rate, Thanks. I knew the exhaust flange was a T3 ( with a drill out of the upper holes ) but, the oil dump flange ( also a T3) I was unaware of. Thanks to Nish. We`re talkin` Holset here not Garrett. Quote Link to comment Share on other sites More sharing options...
gearheadstik Posted December 31, 2007 Share Posted December 31, 2007 Durrr Who's Garrett? Durrr Quote Link to comment Share on other sites More sharing options...
rvandivort Posted January 3, 2008 Author Share Posted January 3, 2008 Good Question! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.