johnnyddn Posted May 3, 2008 Share Posted May 3, 2008 I got a non-EGR intake manifold installed and I now have a large hole in the side of the exhaust manifold that the EGR used to run to. I was wondering if anyone knew what size bolt or plug I can get to plug that exhaust manifold up with? Quote Link to comment Share on other sites More sharing options...
steveosupremeo Posted May 4, 2008 Share Posted May 4, 2008 22x1.5 go to oreilly auto parts or somewhere of the like, look in the oil drain plug section and there is a plug that size with a 3/8 square drive inverted to tighten/loosen. but it should say 22x1.5 on the pack. Quote Link to comment Share on other sites More sharing options...
jeffer949 Posted May 4, 2008 Share Posted May 4, 2008 lol I couldnt get the plug out of mine so i cut it off and put a bolt in it and welded it up lol Quote Link to comment Share on other sites More sharing options...
steveosupremeo Posted May 5, 2008 Share Posted May 5, 2008 yeah, thats what a lot of my friends have done on their KA-T 240sx's. its also cheaper if you can weld. the plug I speak of is around $12. Quote Link to comment Share on other sites More sharing options...
johnnyddn Posted May 6, 2008 Author Share Posted May 6, 2008 Hey thanks Steveosupremeo, that M22 x 1.5 worked perfectly. I picked one up at Meyer's auto parts and it was only $3.50. I'm glad I didn't have to go to the junk yard and pull a non-egr exhaust manifold. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.