ukcats07 Posted October 10, 2009 Share Posted October 10, 2009 Will any molybdenum di-sulfide grease work for a cam break-in or should I just go ahead and order some cam break-in-specific moly lube from summitt, etc.? Quote Link to comment Share on other sites More sharing options...
grumpyvette Posted October 10, 2009 Share Posted October 10, 2009 (edited) ANY MOLY grease will sure be better than just oil alone or oil with EOS alone, but the moly cam lubes designed for break-in are supposed to have slightly more MOLY,and are designed, to wash off slowly and yes IVE used MOLY axle grease with great results a few times in the past when I was about 20,and had zero problems, but ID rather recommend use of the correct assembly lube BECAUSE its designed to dissolve in the oil and have a minimal effect on clogging the oil filter which the moly axle grease IS not designed to do, remember you'll want to replace the oil and filter after about 1-3 hours run time, to remove the moly and any metallic crud in the oil from the lifters laping in http://forum.grumpysperformance.com/viewtopic.php?f=52&t=282 http://forum.grumpysperformance.com/viewtopic.php?f=52&t=2166 http://forum.grumpysperformance.com/viewtopic.php?f=52&t=1489 http://forum.grumpysperformance.com/viewtopic.php?f=52&t=130 Edited October 11, 2009 by grumpyvette Quote Link to comment Share on other sites More sharing options...
ukcats07 Posted October 12, 2009 Author Share Posted October 12, 2009 Thanks grumpy, I was hoping you would answer....straight and to the point. I appreciate the response. Doug Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.