cyl head help motors almost done

[vega]

Ok I have most of my motor mostly built now its a 350 bored to a 360. I am using stock rods that have been approved by my builder. Its a 4 bolt main. I am using hyper. pistons. and a lunati cam.

 

that's the cam kit i have.

http://www.lunatipower.com/Product.aspx?id=2505&gid=309

 

Currently i have no heads, intake or carb. i do have a full serp system.

 

I have been pondering getting new vortecs from summit but is this really going to be my best bang for the buck? I am looking for 350hp at the crank. i don't really want a lot of tq unless its higher up in the rpm range. (see my other threads)

 

I was looking at these.

http://www.summitracing.com/parts/CCA-12403

Or these

http://www.summitracing.com/parts/SUM-151124

 

Unless you guys have some better idea. Btw I am not really looking to any more machine work, i just want something out of a box bolt on pretty much.

 

So- i need opinions and facts. I am looking to cheap out here if i can. Its only 350hp, i don't need or want more.

 

Thanx in advance-

vega

 

btw using a 700r4 out of a 3/4 ton van

[grumpyvette]

the vortec heads

http://www.summitracing.com/parts/SUM-151124

 

with their higher port entrance angle are usually superior,

and with the cam you selected I,d go that route

Id suggest this intake

http://www.summitracing.com/parts/CMB-03-0075/

Edited May 28, 2010 by grumpyvette

[vega]

the first or second set of heads? or something different?

Edited May 27, 2010 by vega