regina

"My Nissan manual says 94 to 123 foot lbs on the rear axle bearing lock nut." You should scan the pages related to this change and post on here.

I've never been quite sure what it is that I have. I pulled some pieces from a yard and they went together. When purchasing them the center casing was marked as a R200 Z31 which was written on the casing. . The cradle was definitely off a 280zx, and as for the axles, I had no idea, just went around till I found something that fit the open center. . I have purchased a 2 way clutch type lsd for a r32. This physically fits into the R200, but am having trouble finding some input shafts to suit the lsd center. Will then have to re spline some axles to fit. Cheers.

Is this a R200 from a z31?

You mentioned earlier the possibility of: "Alternately, you could get the ZXT bearing assembly resplined to match to the Pathy axle (Bryan is opting for the former)." Did he ask about this alternative, or was it a similar story, not enough meat to make the cuts?