Search the Community
Showing results for tags 'bind'.
-
I purchased a 240z that had a r200 swap conversion installed including the CV's and Stub axles. I had also previously purchased an r200 CLSD and CV shafts. I went ahead and swapped in the CLSD I have known about binding issues especially in the 240's but when I measured the CV axles from the open diff compared to the CLSD they were the same size. There for i figured my car would not have binding issues. I had Previously heard a clunk and bind but i thought this was due to some play in the transverse link. Now that I've done more research I've discovered that my dumb ass should have purchased shorter shafts and not placed the original z31 CV's which was the clunk caused by axle wrap and bind. Ive drove about 50 miles on the CLSD and have started to hear a rotational clicking/ticking/clunk(Not Good as I know and once again I am a dumb ass for this) I heard the noise after heavy driving and putting real stress on the rear end. This leaves me with 3 questions: 1. Did I destroy the R200 CLSD? (I did have it inspected previously and everything looked great) 2. Should I bother with buying the shortened shafts, is the noise an internal differential problem? 3. If the diff is fine where has the majority of the damage inquired. What are your thoughts I am not sure what to do as I may have destroyed this diff. Please let me know what you all think. Thank you your inout is appreciated.