Search the Community
Showing results for tags 'fitment'.
Found 2 results
-
Hey all, bought a pair of wheels with some positive offset, so I got a set of 25mm wheel spacers all around to make them fit. I went with the pair listed at zcardepot: https://zcardepot.com/wheel-spacer-set-pair-1.html I was hoping this would "ensure" that they fit all around (since zcardepot specializes in z-cars) but alas, the fronts do not. On the front (stock) hub, it seems that rubber-ish (might just be gunk lol) piece sticking out doesn't clear the center bore of the spacer. I need about 1/8" more clearance. See the following pics. Should I have expected this? Is there just gunk build-up on my car that needs to be cleaned off? What is this rubber extension anyway? Am I screwed unless I get new hubs? FYI - the wheels themselves have 73.1mm inner bore (~2 7/8") and would likely fit on the hub if they were correct offset. I have to use a hub ring to properly center them on the spacer outer edge. Gap when fitted: The center bore appears to be machined out to compensate, but it is just a bit too narrow: OEM wheel has 2 7/8" inner bore: Spacer has 2 5/8" inner bore: -
Ordered a Tilton 75 TIL-75-875U and there's no way it will fit. the diameter of the C MC will rub on the 8.5 MC. Running a T56 and Wilwood 6/4 on the Z. Anyone else have this problem? Ideas? Seems like I would need a 8" or smaller MC or alternate Clutch MC than the recommended Tilton 75 series... ugh
