Milenko2121 Posted June 5, 2013 Share Posted June 5, 2013 (edited) I'm installion dual 12" electric fans so I need to replace the studs with bolts. What is the thread size on these? Been searching for awhile, and can not find it. Thanks Edited June 5, 2013 by Milenko2121 Quote Link to comment Share on other sites More sharing options...
78zstyle Posted June 5, 2013 Share Posted June 5, 2013 You can use nuts. Quote Link to comment Share on other sites More sharing options...
Administrators RTz Posted June 5, 2013 Administrators Share Posted June 5, 2013 6mm. Sorry, I don't recall the pitch and I'm 'away', else I'd check. Quote Link to comment Share on other sites More sharing options...
beermanpete Posted June 5, 2013 Share Posted June 5, 2013 M6 x 1.0. Quote Link to comment Share on other sites More sharing options...
LanceVance Posted June 5, 2013 Share Posted June 5, 2013 (edited) Glad you posted this, I was planning on looking this up when I noticed it in the new content! Edited June 5, 2013 by LanceVance Quote Link to comment Share on other sites More sharing options...
Milenko2121 Posted June 5, 2013 Author Share Posted June 5, 2013 (edited) Ah, thank you I can't use nuts because there is a gap with the thread. Edited June 5, 2013 by Milenko2121 Quote Link to comment Share on other sites More sharing options...
beermanpete Posted June 5, 2013 Share Posted June 5, 2013 We ran into the same issue when we went to an electric fan. The studs have a section without any thread that is longer than the thickness of the pulley hub. The nuts won't tighten down to the pulley without a ridiculous amount of washers to take up the space. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.