technicalninja Posted January 13, 2004 Share Posted January 13, 2004 Tried search to no avail... What driveshaft will work for a 73 240z with the Borg-Warner T5 installed in it? Will the stock 82/83 ZX driveshaft work? Is a replacement front yoke available that would fit on a 240 shaft? Any hints or ideas would be appreciated. Quote Link to comment Share on other sites More sharing options...
BillZ260 Posted January 13, 2004 Share Posted January 13, 2004 This is what SpeedRacer told me... I made all my mounts per JTR including the trans mount. I did buy my driveshaft from MSA but the two they had available were too long so I had them custom make a shorter one. They did not charge me extra to do this. I have a 327 SBC with a Camaro T-5 trans. I used a 1984 and up Corvette bell housing so the trans is not tilted over at 14 degrees. I did have to change the trans mount because of this and straighten out the shift lever. Quote Link to comment Share on other sites More sharing options...
240zprace Posted January 13, 2004 Share Posted January 13, 2004 the shaft from turbo car will not fit unless youcut 2-3", then reweld it up again. only then it will work Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.