boostin280zx Posted November 5, 2005 Share Posted November 5, 2005 Drove my car around yesterday finally on ms2. It runs a lot smoother than the stock ecu did. I was wondering if some of the codes from MSnS-extra would would work with ms2. I want to get the boost control things for spark retard and stuff that I had in msns-e. If i put the files from that into my car1 mtcg folder would it show up in megatune? And when you run dual tables can you have 1 table with 200-3500 rpms and 10-100kpa and the 2nd table have 3500-6500rpms and 100-kpa to 200kpa?So when the motor revs above 3000 rpms and sarts building bosst it will start reading from the 2nd table? I asked a few people about this at this car meet last night but they said dual tables are for controlling v-tech engines. Is that true or is that just dual tables on honda tuning stuff? Quote Link to comment Share on other sites More sharing options...
Guest 73Turbo240z Posted November 5, 2005 Share Posted November 5, 2005 So instead of running a MSnS v3.0 you went to MS2? Quote Link to comment Share on other sites More sharing options...
boostin280zx Posted November 5, 2005 Author Share Posted November 5, 2005 Yeah, i wasn't going too, but when i order my ms1 v3 partial kit they sent me the ms2 daughter card on accident i guess. Quote Link to comment Share on other sites More sharing options...
Brad-ManQ45 Posted November 8, 2005 Share Posted November 8, 2005 can't use any extra code, MS2 is C whereas MSI is assembly... Quote Link to comment Share on other sites More sharing options...
boostin280zx Posted November 8, 2005 Author Share Posted November 8, 2005 ok. Well now i need to fix my o2 sensor. I thought it was broken but i hooked my a/f guage up 2 it and it works. In megatune it stays at 2.8 or something like that. It never changes. I think it was warmed up when i was doing it. When i hook it up to the stimulator it it doesn't go all the way to lean and all the way to rich. I only stay on the lean side. I twist the nob and it skips a couple of dots and then stays almost in the middle, then when i turn the nob to bring it down i cuts off then 3 dops pop up. What stuff on the board is for the o2 input. I thought my sim was broken but it worked just fine on my v3pcb ms1. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.