v80z Posted December 16, 2005 Share Posted December 16, 2005 HEy I have a Corvette slave cylinder with the JTR recommended Tilton MAster. The Datsun line fit directly into the corvette slave with a thread pitch of 1.75. The tilton has a thread pitch of 1.00. JTR's only recommendation was a -3 an braided line. So I need a compression/-an fitting with a 1.75 for the slave and one with a 1.0 for the master and a 3 ft -3 an aeroquip style braided hose. The hose should be no problem. Any ideas on where to find the other pieces. I was wondering if anyone else has faced this dilemma. Joe Quote Link to comment Share on other sites More sharing options...
rudypoochris Posted December 16, 2005 Share Posted December 16, 2005 Did you try summitracing.com? Quote Link to comment Share on other sites More sharing options...
steve72z Posted December 16, 2005 Share Posted December 16, 2005 I have had good luck going to local hydraulic shops that work on heavy equipment and tow trucks. Many of them cary the pieces or can order them. Quote Link to comment Share on other sites More sharing options...
DaleMX Posted December 16, 2005 Share Posted December 16, 2005 I used Earls stuff on the master, but ended up drilling and tapping the fitting on the clutch slave. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.