240Z_Master Posted January 20, 2011 Share Posted January 20, 2011 (edited) Since my car isn't near me right now.. I had a quick question... #1) Are there any ports/plugs that you can remove on the intake side of the block to access water temp? #2) What thread pitch/size is the plug/bung? Here's why I need to know this... I've got a 1/8 NPT water temp probe I need to stick into the block, but don't want to redrill/rethread my GReddy intake manifold. Here is what I'm looking at... just concerned on what size to run... EBAY Autometer Adapter Edited January 20, 2011 by 240Z_Master Quote Link to comment Share on other sites More sharing options...
ZT-R Posted January 20, 2011 Share Posted January 20, 2011 i believe there is a plug under the rear turbo, not sure on the size. some say they dont have it but mine did Quote Link to comment Share on other sites More sharing options...
240Z_Master Posted January 20, 2011 Author Share Posted January 20, 2011 i believe there is a plug under the rear turbo, not sure on the size. some say they dont have it but mine did I'm sure mine does... I was just trying to run the wires on one side, but one wire wouldn't hurt anything. Now to figure out that dang size. Quote Link to comment Share on other sites More sharing options...
Canadianz Posted January 20, 2011 Share Posted January 20, 2011 I ran mine off the lower Rad hose using a 2 inch piece of pipe with a bung welded in. You could also Tee off one of the hoses that goes to the heater area... Quote Link to comment Share on other sites More sharing options...
240Z_Master Posted January 20, 2011 Author Share Posted January 20, 2011 I ran mine off the lower Rad hose using a 2 inch piece of pipe with a bung welded in. You could also Tee off one of the hoses that goes to the heater area... I removed most of my heater hoses... and on top of that... I can't remember what size they were... and I would have to find a barb fitting with a T for a 1/8" NPT fitting... Would rather just get an adapter bushing and call it a day. Quote Link to comment Share on other sites More sharing options...
240Z_Master Posted January 22, 2011 Author Share Posted January 22, 2011 No one knows the thread pitch/size for the water plugs on the block? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.