ZuL8r

I really like the look of your wheels and am thinking about ordering some. Can you confirm that they are 17 by 9.5 with 5in backspacing. Spacers or no spacers? Do they fit without coilovers, and lastly what size tires are you running? Thanks

I really like the look of the wheels in the pictures above with the black center so I called centerline today and was quoted $385 per wheel for the Thrusters in 17 by 9.5. That is rediculous. Jegs has them listed at $269.99 but I will have to check and see if they can get me the right bolt pattern at that price. Does anybody have any hookups on centerline wheels?

The a/c compressor will hit the frame rail in the stock position on the F-body LT1. The Corvette motors have it mounted high on the driver's side of the motor like the alternator is on the passenger side. The a/c delete bracket also hits the frame rail. You will have to make a custom pully bracket that clears the frame rail.

It looks like the offspring of a Lotus Elise and a NSX.

First let me say good job. It looks like you are learning quickly. I may be looking at them wrong but it seems that your weld is below the face of the material on some of the first pictures. This introduces a stress riser to the material. It is best if the weld is even with the material but its ok if it is higher. I could tell you more with some horizontal pics.

The 7M motors are known for rod knock aswell.

Ok, I am now just as confused as before. There is a post labeled bat on the alternator and there is the plug on the bottom that has one wire comming off of it. What do I wire up to the post and what do I wire up to the plug? I thought it was 12v from the battery to the post on the alternator and a switched 12v ignition lead to the plug on the bottom. Is this right or how far off am I? Pictures or diagrams would be awesome.

Ok after reading about the LT1 Alternator over in the electrical forum I am getting a better idea of how it works. The post on the back of the alternator gets wired to the positive battery post and the small wire coming off of the connector on the bottom of the alternator gets a switched ignition positive feed. Is this correct?

Can someone please explain to me how to wire up the LT1 alternator to my 76 280z. I have the JTR manual but I am still not sure. Picture would be great too.

http://www.speedspecialty.com/store/view_product.php?product=lt1altbracketV2 The pictures on this website are not great but it looks like another possible option for running just an alternator. I can't tell from the picture if it will clear or not because the picture looks photochopped. What do yall think?

On that list it would have to be the IS300 for me. Sweet car, Awesome styling.

Can someone explain to me how you gutted the power steering pump to use it as a pulley only. Its on a 1997 F-body LT1.

That is insane! I wanna see videos asap.

Flame away if you like but I have searched for about an hour. Is anybody using the stock LT1 T56 slave cylinder on their LT1 conversion. I am a little tight on funds and it came with my motor and tranny. Same question on the Master Cylinder too, or I may have to bite the bullet and get the Tilton unit.

Are you using a plastic clutch alignment tool? If so the tool might have flexed out of alignment enough to cause a big headache. This has happened to me before.