Jump to content
HybridZ

braid11

Members
  • Posts

    10
  • Joined

  • Last visited

About braid11

  • Birthday 05/03/1959

Profile Information

  • Gender
    Male
  • Location
    Whistler , BC

braid11's Achievements

Newbie

Newbie (1/14)

  • Dedicated Rare
  • Week One Done Rare
  • One Month Later Rare
  • One Year In Rare

Recent Badges

10

Reputation

  1. Check out their website: gallery: customer cars: page 4. Lots of pics of RB25DET into a 260z using the same gages etc. https://www.zfever.com/v1/Customer-Cars/
  2. Hoping to buy a pair for my 240. Emailed, is this still available? tom
  3. http://www.baddogparts.com/ Scroll down to the Seat Brackets.
  4. I have been researching this for my 240. Here are links to some great threads. The Weber site says no regulator is required. The rest of the links show the install in some detail, with pics and diagrams. Good luck. http://www.classiczcars.com/forums/showthread.php?p=91996&highlight=oil+pressure+thread#post91996 http://www.racetep.com/webfuelspark.html#webfuel http://www.classiczcars.com/forums/showthread.php?t=21052 http://www.classiczcars.com/forums/showthread.php?p=199702&highlight=oil+pressure+thread#post199702 http://www.classiczcars.com/forums/showthread.php?p=252549&highlight=oil+pressure+thread#post252549 Tom.
  5. M son is driving from BC to Ontario in a 240z with 10,000miles on a rebuilt L28 triple webers. 280 distributor, xr700/PS92 ignition. Fuel pressure is 3.5 psi. It ran fine for 12 hours to Calgary, in heavy rain. Now , without any load, sitting in the driveway, he says it sounds perfect at idle, and it revs up high just fine. But as soon as he tries to let the clutch out to drive, it stumbles, coughs, won't develop power. It then tries to rev up and go, then stumbles again. At high RPMs it will go, but not up a hill. It will not maintain power up a hill, or under load. He noticed a spark plug wire came off, and another lost the connector end, but that was fixed, and the problem remains. Is there anyone in Calgary who I could send him to, mechanic or enthusiast. Will pay cash. Or any advice is appreciated. This was my long term project/rebuild, that I put tons of time and money into. I donated to him as he is getting married. I ran it daily for a couple years. Then it sat for several years, and was run every couple months. But it ran fine for 10+ hours today over the Rockies. Thanks for any advice. Tom
  6. Looking for help please, I searched for hours with no luck. My 1972 240 with HI-6 spark box, P92 coil, and 280z distributor has worked perfectly for many years. Now it won't start. No spark at the plugs. The HI-6 status light does not blink when I hold the key on start, cranking the motor over. This is supposed to mean the HI-6 is not receiving a trigger signal from the distrubutor. A mechanic said the HI-6 box has failed, it's about 10 years old (it's been in an area that gets moist/damp for some of the year). Before I replace it, I would like to make sure the distrubtor is not the problem. So is there a way to test if the distributor is sending a trigger pulse from the pick-up coil? Tom
×
×
  • Create New...