Search the Community
Showing results for tags 'air filter'.
Found 3 results
-
I put this in the "turbo" section cus I didn't see any other appropriate place, but it probably applies to the turbo somehow. I have a 1978 280z with an '82 L28ET engine. It is stock everything except for an added oil cooler. I currently have a SUPER DIRTY K&N air filter that sits in front of my radiator via some custom piping. I think the previous owner put this on in 2004 and hasn't changed it since, so I decided I would just get a new one rather than try to clean it (see below). I found the current filter online: https://www.knfilters.com/search/produ
-
My 280z has an AZ zcar 4 barrel Holley carb manifold on it and I have deleted the PCV, that would normally vent back into the stock EFI manifold, with just a filter venting to atmosphere. The engine runs great and pulls hard but I've noticed oil fumes while Im driving and engine braking, now I have no engine oil leaks and my engine doesn't burn oil, so i have isolated the smell to the air filter that Ive attached to the Crankcase vent tubing on the side of the engine(shown in pictures). My question is, can I run any inline PCV valve with a rubber hose running down toward the underside of the c -
So I've only posted a couple times and I have lots of pictures of the things I did/do to my Z, and I do have a question. But first a little show and tell . I was frustrated I couldn't find air horns for my Weber carbs that I thought where correct (opinion only), so part owning a machine shop, i made these. I chose to make them two piece because they are easier to machine being thin wall and I only need to make the bell half if I want to change the design later. I have two questions .. 1) is there anyone that makes filter that are actually filters?. (As opposed to just mesh screens I'
