Search the Community
Showing results for tags 'pin'.
-
Having pulled my spindle pins three times in the past few years and somehow managing to save them. On my last attempt I finials messed up the threads to the point were replacement was going to be a must. Having done some digging around I decided to go the 5/8 bolt route There are many people who say do not do this but if you look at the techno tuning toys rear lower control arms. Granted they are using a hime joint they use a 5/8 bolt. On these grounds I set off to find the right bolt for the job and this is what I came up with. From Fastenal a 5/8-11 x11 yz8 haven taken many measurements and
-
So I've got a couple other threads about Printing car parts on my 3d printer. Well on my 300zx, the upper window pin again broke yesterday. This allows air to whistle while driving and water to leak in with the rain. I'm tired of tearing the door apare to fix a cheaply made part. So, I started looking into what can be done to fix this issue. Well the stock pin has a white plastic ring around a metal ball end, allowing for some movement. The plastic is what breaks. I looked at it and figures a 5/16" washer would almost fit over the ball portion, but would not fit past it. That woudl b