ehime Posted June 23, 2011 Share Posted June 23, 2011 So I'm the majority of my way through a skinny bumper conversion for my 280Z, while trying to stick the 240Z valance in place of the 280Z valance I noticed that, while the outers (after separating into all three parts) will bolt on, the centre of the valance will not work do to the centre bolt in location of the 280Z/240Z are quite a bit different. What are my options at this point? Quote Link to comment Share on other sites More sharing options...
RB26powered74zcar Posted June 24, 2011 Share Posted June 24, 2011 Can you fab up a bracket? Picture would help... Quote Link to comment Share on other sites More sharing options...
Pharaohabq Posted July 12, 2011 Share Posted July 12, 2011 Drill. Drill a hold for the bold in the bracket not the valence. a bent strip of steel could also make up the difference. That is if it's where I think you're talking in the center of the valence. Quote Link to comment Share on other sites More sharing options...
scaotty Posted July 14, 2011 Share Posted July 14, 2011 Fab it up! Thats what i did. Quote Link to comment Share on other sites More sharing options...
nullbound Posted July 14, 2011 Share Posted July 14, 2011 Cutoff wheel, either on the spoiler or on the metal parts that are blocking it. Here's a 280 I used to have that I installed a 240 Kaminari spoiler on: And the red circles below show what I had cut on the car so I could mount that spoiler on that car: Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.