Roberts280Z Posted March 5, 2018 Share Posted March 5, 2018 I have seen this topic briefly mentioned, and also seen a 240Z video showing this. I think the seat bracket mounting is different between the 240Z and 280Z. If it is possible, I would like to leave the brackets in place. I've started removing the floor, and I'm not yet sure if it is possible to remove the floor pan spot welds to the inner rocker panel in the vicinity of the seat brackets. Thanks in advance Quote Link to comment Share on other sites More sharing options...
Neverdone Posted March 5, 2018 Share Posted March 5, 2018 Anything is possible with a drill, angle grinder, and a welder. 1 Quote Link to comment Share on other sites More sharing options...
Geno750 Posted March 5, 2018 Share Posted March 5, 2018 There's a series of spot welds on the floor and tunnel/door frame, just don't drill out the ones on the trans tunnel/door frame when you remove the floor. It makes it harder but it's doable. Quote Link to comment Share on other sites More sharing options...
Roberts280Z Posted March 5, 2018 Author Share Posted March 5, 2018 Thanks guys, I think I was literally looking at this from the wrong angle. Parts of the floor pan will be easier to remove from underneath. I should have realized that last night while drilling out some of the seat bracket-to-floor pan spot welds from underneath, but my arm was so tired it was about to fall off. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.