mas28O Posted August 4, 2003 Share Posted August 4, 2003 I took my 240z out today for the first time. Lt1/4l60e. The car ran good but the power was not that good. I still have MAF code. I might try tonight and switch the computer to speed density mode only and see if this helps. Codes 48&84 Mike Quote Link to comment Share on other sites More sharing options...
Mudge Posted August 5, 2003 Share Posted August 5, 2003 You can unplug the MAF to short cut that process of course it will set a code though. Quote Link to comment Share on other sites More sharing options...
mas28O Posted August 5, 2003 Author Share Posted August 5, 2003 Looks like part of my problem is with the trans code. The trans is not down shifting right. I put the car in 1st and got on it and it moves. Looks like I have to fix the bugs. Mike Quote Link to comment Share on other sites More sharing options...
80LS1T Posted August 5, 2003 Share Posted August 5, 2003 Have you modified your engine at all or is it still stock? Glad to here that you got to finally drive it. Its it a great feeling of acomplishment when you go on that fist test drive! 8) It's like "yeah thats right I built this car!" I smiled from ear to ear when I took mine out on its first run! Guy Quote Link to comment Share on other sites More sharing options...
mas28O Posted August 5, 2003 Author Share Posted August 5, 2003 Stock right now with 150 shot of nos, but as soon as I get all of the bugs out I have a set of heads and cam for it. Quote Link to comment Share on other sites More sharing options...
mas28O Posted August 5, 2003 Author Share Posted August 5, 2003 I have code 81, 82, 84 all trans codes. It looks like something is not hooked up right. I took the MAF out of the program so no code there anymore. Quote Link to comment Share on other sites More sharing options...
mas28O Posted August 6, 2003 Author Share Posted August 6, 2003 looks like the problem was with the speed sensor. The pin was not all of the way in where it goes in the computer. It runs good now, the LT1 has alot of low end power. I ran into a problem with my R230 shaft but I should have that fixed soon. Mike Quote Link to comment Share on other sites More sharing options...
JustAFantaZ Posted September 6, 2003 Share Posted September 6, 2003 Congrats Mike! Hopefully you'll sell it to me when you get your next project going later on Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.