sqweekykneecap Posted July 1, 2011 Share Posted July 1, 2011 well i went to this drive line shop around me, tried getting a drive shaft made up using the instructions that garrett gave us. NOW, the question that came up is, the "Length from the flange to output shaft 29 1/16" " talking weld points? or the center of the flange yokes? and "output shaft" is obviously referring to the slip yoke correct? thanks Link to comment Share on other sites More sharing options...
rossman Posted April 21, 2012 Share Posted April 21, 2012 I'm looking at the giant hole in my floorboard.... And was wondering what you guys are using to close out the hole. I'd like to have some sort of rubber boot like the stock inner boot. I tried the stock boot but the hole is too small for the shifter and in the wrong location. Link to comment Share on other sites More sharing options...
sqweekykneecap Posted April 21, 2012 Share Posted April 21, 2012 On 4/21/2012 at 7:26 PM, rossman said: I'm looking at the giant hole in my floorboard.... And was wondering what you guys are using to close out the hole. I'd like to have some sort of rubber boot like the stock inner boot. I tried the stock boot but the hole is too small for the shifter and in the wrong location. meh i just used some vinyl sheet. no air gets through Link to comment Share on other sites More sharing options...
Recommended Posts