rztmartini Posted December 8, 2006 Share Posted December 8, 2006 if possible, can anyone post pictures of their relay boards? i am interested in particular about the power hookups in the upper right hand corner, next to the injector leads. Thanks all... Quote Link to comment Share on other sites More sharing options...
rztmartini Posted December 10, 2006 Author Share Posted December 10, 2006 This right here...not sure what I should do... Quote Link to comment Share on other sites More sharing options...
big-phil Posted December 10, 2006 Share Posted December 10, 2006 I was thinking the same thing, I guess we just solder the wires in? If I get to that point I'll post a picture. Quote Link to comment Share on other sites More sharing options...
Boosted1503 Posted December 11, 2006 Share Posted December 11, 2006 I'm not familiar with the board but just by looking at it i'm assuming u solder in wires for a 12 volt switched source and a wire for 12 volt from the battery I'd run an inline fuse from the battery on that wire. And i'm not to certain on that top wire something with the engine can u get a clearer picture of the top labeling? Quote Link to comment Share on other sites More sharing options...
big-phil Posted December 11, 2006 Share Posted December 11, 2006 thats engine ground Quote Link to comment Share on other sites More sharing options...
Boosted1503 Posted December 11, 2006 Share Posted December 11, 2006 thats engine ground LOL duh.....So then yea you'll just have to solder in those three wires. Quote Link to comment Share on other sites More sharing options...
jkube Posted December 11, 2006 Share Posted December 11, 2006 I just used a nut and screw c/w a ring connector on the wires Just be sure to trim the screw back so it doesnt short out on anything Jeff Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.