VinhZXT Posted October 22, 2007 Share Posted October 22, 2007 I just found some good info and I want to share with everyone. The videos are exellent. Have fun. http://www.fgci.com/howto/ht004hand_lay_up.html http://www.fgci.com/howto/ht003fiberglass_mold.html http://www.freemansupply.com/video.htm http://www.jgreer.com/Foam%20Page.htm Quote Link to comment Share on other sites More sharing options...
Slow_Old_Car Posted October 22, 2007 Share Posted October 22, 2007 This is good info to have, i just got some fiberglass parts from a old Solo II Z that i'm dismantling, and while the fiberglass parts are rough from years of racing... i was trying to figure out how i could make mold's of them so that the design isn't lost to time and wear. I'll have to go over those links and see if i think i can do it... always would be nice to crank out vintage race bodywork. Just never have had a clue how it works. Quote Link to comment Share on other sites More sharing options...
VinhZXT Posted October 22, 2007 Author Share Posted October 22, 2007 I am in the process of doing the same thing on my kit. You gotta check out the videos link. The videos save you a lot of readings. Check out all the videos they have on that link. GL. Vinh Quote Link to comment Share on other sites More sharing options...
m1ghtymaxXx Posted October 23, 2007 Share Posted October 23, 2007 Awesome post. I vote sticky status. Quote Link to comment Share on other sites More sharing options...
Austenp405 Posted October 24, 2007 Share Posted October 24, 2007 I second sticky status. The videos are awesome. There's some great info on Fibreglast.com too... http://www.fibreglast.com/contentpages-main-Learning-Center-283.html Quote Link to comment Share on other sites More sharing options...
cygnusx1 Posted October 24, 2007 Share Posted October 24, 2007 I can actually watch these at work and not worry about the boss. It's pretty closely related to what I do. Nice videos. Thanks, Vin. Quote Link to comment Share on other sites More sharing options...
VinhZXT Posted October 24, 2007 Author Share Posted October 24, 2007 I've been to that fiberglass site many times. Notice their videos are not for free. The other site's videos covered all the basic steps which is what I needed. The rest is just depends on your learning skills and imagination. I am ready to build my mold as soon as I get the plug completed. V. Quote Link to comment Share on other sites More sharing options...
VinhZXT Posted November 1, 2007 Author Share Posted November 1, 2007 More good info here: http://www.fiberlay.com/howto/issue1.htm Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.